Page 3
For technical questions, please call 1-888-866-5797.
Item 56683
Controls
U
- Unit Button: Cycle through available Torque
Units (ft-lb, in-lb, nm, and kgm), Angle Mode, or
Torque then Angle.
On/Off
- Power Button: Press to turn on Wrench.
Press and hold for 3 seconds to turn off Wrench.
Wrench will also automatically turn off after 2
minutes of non-usage.
M
- Menu Button: Press to enter menu.
+/-
- Increase and Decrease Buttons: Use to
increase or decrease torque and angle settings.
Also used to navigate menu.
P
- Preset Button: Used to reset values. After
adjusting settings (Torque Value, Torque Units,
and Mode), press Preset Select button to set as
a preset. After using the Torque Wrench, applied
values can be cleared by hitting Preset Button.
Torque Mode, Angle Mode, Torque then Angle Mode
CAUTION!
Wear ANSI-approved safety goggles
during use.
1. In
Torque Mode
, when force is applied, the LCD
display will show real applied Torque Value.
2. Applied Torque Value will flash for ten
seconds. Torque can be applied until reaching
set target. If no torque is applied, screen will
revert to displaying target preset values.
Note:
Flashing can be bypassed by hitting Preset
Button. This will return LCD display to preset values.
3. If Torque reaches the set value, the Wrench
will vibrate.
4. Press the Unit Button to cycle through to
Angle Mode.
In Angle Mode, the LCD display
will show the actual applied Angle Degrees.
5. The display will flash for ten seconds. During
this time, force can be applied until reaching
set target. If no force is applied, the screen
will revert back to preset values.
6. If Angle Degrees reaches set value, Wrench
will Vibrate.
7. Press Unit Button to cycle through to
Torque
then Angle Mode
(displayed as “T then A”
mode on LCD display).
8. In Torque then Angle Mode, you can preset
Torque Value. When Wrench reaches preset
Torque Value, it will automatically switch to
Angle Mode (angle preset value must be
individually set in Angle Mode first).
Progress Lights
1. The Progress Lights indicate how close the
actual applied value is to the preset value.
2. Progress lights will turn red when real value is
between 40% and 79.9% of preset value.
a. First Progress Light will light up when actual
value is between 40% and 52.9%.
b. Second Progress Light will light up when
actual value is between 53% and 65.9%.
c. Third Progress Light will light up when
actual value is between 66% and 79.9%.
3. Progress Lights will turn yellow when real value
is between 80% and 95.9% of preset value.
a. First and second Progress Lights will turn
off. Third Progress Light will turn on when
actual value is between 80% and 84.9%.
b. Fourth Progress Light will turn on when
actual value is between 85% and 89.9%.
c. Fifth Progress Light will turn on when actual
value is between 90% and 95.9%.
4. Progress Lights will turn Green when the
actual value is above 96% of the preset value.
a. Third and fifth Progress Lights will turn off.
Fourth Progress Light will turn green when
actual value is between 96% and 99.9%.
b. Fifth Progress Light will turn on when actual
value is between 100% and 103.9%.
Note:
Wrench will vibrate if actual value hits
100%.
c. Sixth Progress Light will turn on when actual
value is above 104%. Lights will begin
flashing when applied value is above 104%.
