Page 3
For technical questions, please call 1-888-866-5797.
Item 57191
IMPORTANT SAFETY INFORMATION
TO PREVENT SERIOUS INJURY AND DEATH:
Basic Safety Information
1.
Do not pull more than rated load. Be aware of
dynamic loading!
Sudden load movement may
briefly create excess load causing product failure.
2.
Do not operate while puller restricted from
forming a straight line with loading direction.
3.
Do not operate puller with twisted, kinked, or
damaged wire rope.
Inspect wire rope carefully before every use.
4.
Do not operate a damaged or malfunctioning
puller.
Inspect puller carefully and
test operation before every use.
5.
Do not use for vertical lifting.
Do not lift people or lift loads over people.
Falling loads can injure or kill people.
6.
Do not operate puller with a lever extension.
7.
Do not operate with rope not
centered in its groove.
8.
Do not remove or cover warning labels and/
or tags.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
9. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
Setup Specific Safety Information
1. The supporting structure the puller is mounted
to must be designed to withstand the loads and
forces imposed by the puller for the rated load.
2. Install in location that allows the operator
to move and stay clear of the load.
3. Inspect the puller as explained in
Frequent Inspection on page 8
after setup but before use.
Inspection, Testing, and Maintenance Specific Safety Information
1. Perform a “Frequent Inspection”
at least monthly, see page 8.
2. Perform a “Periodic (Thorough) Inspection”
at least yearly, see page 9.
3. More frequent inspections are needed
for pullers that are used heavily.
4. Raise test loads only to the minimum extent needed
and stay well clear of load at all times during testing.
Operation Specific Safety Information
1. Wear ANSI-approved safety goggles,
ANSI-approved hard hat, and
steel-toed work boots during setup and use.
2. This product is not a toy.
Do not allow children to play with or near this item.
3. Use as intended only.
• Do not use to handle molten material.
• Do not use for aircraft purposes.
• Do not use to link towed vehicles.
4. Keep hands clear of moving parts.
SAVE THESE INSTRUCTIONS.
SAFETY
OPERA
TION
INSPECTION
SETUP
