Roof Frame Assembly
Note:
Much of this product’s assembly uses slip fit construction. Nut and Bolt connections are required during
proper assembly. Line up all holes on tubes and connectors. Insert Bolt through hole and secure with Nut
installed on the other end. Make sure all parts seat completely and securely. A rubber mallet (sold separately)
can be used to gently tap parts in place to ensure a tight fit. Do not tighten Nuts on the Bolts for the
front and rear tubes. They will need to be removed to install the front and rear canopy walls.
A1
4
3
A2
B1
B
A
A1
B1
B1
B1
A2
A
B
4
4
4
4
4
4
4
4
3
3
3
3
3
3
3
Figure A: Roof Assembly Overview
1. Assemble ridge using three Rails (4) with
4-Way Ridge Connectors (B) between them, and
a 3-Way Ridge Connector (A) on each end. Align
holes and insert six M8x45 Round Head Bolts (20)
and secure with Wing Nut, ends of the Connectors
should be angle down, as shown in Figure B.
A
B
4
A
A
B
4
4
20
4
2. Connect a Rafter (3) to each end of every Connector
(A, B), align holes and insert eight M8x45 Round
Head Bolt (20) and secure with Wing Nut.
Figure B: Ridge Assembly
A
B
A
A
B
3
3
20
3
3
3
Figure C: Rafter Assembly
Page 5
For technical questions, please call 1-888-866-5797.
Item 62860
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
