Item 56349
Page 8
For technical questions, please call 1-888-866-5797.
S
AFETY
O
PERA
TION
M
AINTENANCE
SETUP
Operating Instructions
Using the Work Light
1. To turn the Work Light on, press
the Work Light button.
2. To turn flashing lights on, press the
Work Light Button again.
3. To turn the Work Light off, press
the Work Light button again.
Jump-Starting a Vehicle
Note:
Read the vehicle owner’s manual pertaining
to jump-starting prior to using the Jump Pack.
1. Press the Battery Test button to verify that the
Jump Pack is fully charged. Recharge as needed,
following the instructions in the
“Charging
the Jump Pack”
section on page 6.
2. Turn off the vehicle ignition switch and all
accessories (lights, radio, climate control, etc.).
3. Turn Clamp Power Switch on the Jump
Pack to the OFF position. You may
leave the Work Light on if needed.
WARNING! TO PREVENT SERIOUS INJURY:
DO NOT TOUCH POSITIVE AND NEGATIVE
BATTERY CLAMPS TOGETHER.
3. Connect the red Positive Battery Cable to
vehicle’s positive battery terminal. Connect
the black Negative Battery Cable to a non-
moving metal part of the vehicle.
WARNING! TO PREVENT SERIOUS INJURY:
DO NOT CONNECT TO THE NEGATIVE
TERMINAL OF THE BATTERY.
4. When the correct connection has been made, turn
the Clamp Power Switch to the ON position.
5.
WAIT FIVE MINUTES,
then start the
vehicle. If the vehicle does not start, wait an
additional 3 minutes before trying again.
CAUTION! THE VEHICLE WILL NOT START IF
YOU DO NOT WAIT AT LEAST 5 MINUTES.
6. After the vehicle is started, turn the Clamp
Power Switch to the OFF position. Remove
the black Negative Battery Cable first, and
then the red Positive Battery Cable.
Running DC Appliances
1. Press the Battery Test button to verify that the
Jump Pack is fully charged. Recharge as needed,
following the instructions in the
“Charging
the Jump Pack”
section on page 6.
2. Make sure the total wattage of the appliance
is within the range of the Jump Pack. See
“DC Appliance Compatibility”
on page 7.
3. Make sure that the Clamp Power
Switch and appliance are off.
4. Using a 12VDC Adapter, plug the
appliance into the 12VDC Outlet.
5. Turn on the appliance.
6. When finished using, turn off and
unplug the appliance.
Running/Charging USB Devices
1. Press the Battery Test button to verify that
the Jump Pack is fully charged. Recharge
as needed, following the instructions in the
“
Charging the Jump Pack
” section on page 6.
2. Plug the device into the USB Port.
3. When finished, unplug the device from the USB Port.
