SKU 94670
For technical questions please call 1-800-444-3353.
Page 7
Note: Performance of this tool (if powered by line voltage) may vary depending on variations
in local line voltage. Extension cord usage may also affect tool performance.
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
Unpacking
When unpacking your AM/FM Band Radio, check to make sure that all parts listed in the parts list
on page 10 are included. If any parts are missing or broken, please call HARBOR FREIGHT
TOOLS at 1-800-444-3353. It is important that you read the entire manual to become familiar with
the product BEFORE you operate and use the Radio.
Assembly
Your Radio comes completely assembled. The only assembly required is installation of the back up
batteries.
Installing the Back Up Batteries
1.
Remove the Battery Cover (11)-see Figure 1.
2.
Insert two “AA” Batteries as marked on the inside of the battery compartment.
3.
Set the Battery Selector Knob to BATTERY-see Figure 2.
Operation
Using the Built-In Rechargeable Batteries
1.
Set the Battery Selector Knob to “Generated”.
2.
Pull out the Handle-see Figure 2.
3.
To charge the Radio, turn the Handle rapidly clockwise. Note that turning the Handle for one
minute will give you about 30 minutes of listening time.
4.
Note that when turning the Handle to recharge the batteries, if the radio is on, noise
interference may occur.
5.
The Handle must be turned rapidly in either direction to fully and efficiently recharge
the batteries.
6.
The rechargeable Ni-MH batteries can be used about 300 times.
7.
To maintain optimal battery life, discharge the batteries completely before recharging.
8.
Only recharge the internal batteries when the “Low Battery Indicator Light” comes
on-see Figure 2.
