SKU 95082
For technical questions, please call 1-800-444-3353.
Page 14
AdjuSt ROLLER cASE LEVEL.
If the Roller Case (47) is not parallel
to the base (104), the planer will
produce cuts of uneven depth.
1. Use a test piece to measure the
height of the taper.
2. Turn the Planer off and disconnect it
from the power supply.
3. Fold both Extension Tables up and
lay the planer on its back.
4. Loosen the Head Screw (45) and Set
Screw (44). Loosen the Chain (121)
by sliding the Idler Bracket (114).
5. Rotate the Pan Head Screws (120)
to correct the orientation of the Roller
Case to Base. Each turn of the
Screw will move the Roller Case by
1/16”.
REPLAciNg tHE V-BELt.
1.
Remove the Handle (10).
2. Remove the four Head Bolts (130A)
and Head Washers (130B) from the
Left Cap (1) and Right Cap (11).
Remove both Caps.
3. Remove the Pan Head Screws (68)
from the Fan Housing (78). Slide off
Fan Housing.
4. Remove the V-Belt (65) from the
Pulley (64) and replace with new
135J6 V-belt. Contact Harbor Freight
Tool for replacement belts.
26. Reassemble the Planer.
WARNiNg! if the supply cord
of this power tool is damaged,
it must be replaced only by a
qualified service technician.
PLEASE REAd tHE FOLLOWiNg cAREFuLLY
THe MAnuFACTuReR And/OR diSTRiBuTOR HAS PROVided THe PARTS liST And ASSeMBly diAgRAM in THiS MAnuAl
AS A ReFeRenCe TOOl Only. neiTHeR THe MAnuFACTuReR OR diSTRiBuTOR MAkeS Any RePReSenTATiOn OR
WARRAnTy OF Any kind TO THe BuyeR THAT He OR SHe iS quAliFied TO MAke Any RePAiRS TO THe PROduCT,
OR THAT He OR SHe iS quAliFied TO RePlACe Any PARTS OF THe PROduCT. in FACT, THe MAnuFACTuReR And/
OR diSTRiBuTOR exPReSSly STATeS THAT All RePAiRS And PARTS RePlACeMenTS SHOuld Be undeRTAken By
CeRTiFied And liCenSed TeCHniCiAnS, And nOT By THe BuyeR. THe BuyeR ASSuMeS All RiSk And liABiliTy
ARiSing OuT OF HiS OR HeR RePAiRS TO THe ORiginAl PROduCT OR RePlACeMenT PARTS THeReTO, OR ARiSing
OuT OF HiS OR HeR inSTAllATiOn OF RePlACeMenT PARTS THeReTO.