Page 4
For technical questions, please call 1-800-444-3353.
Item 93575
Installation
1. Choose where you want to mount the
Safe. The supplied mounting Bolts are
for mounting in concrete. If you are
going to mount to another surface, you
must supply the appropriate 3/8” bolts.
If you are mounting on a shelf, make
sure the shelf is weight rated to safely
support the Safe and its contents.
If you are mounting on a wall or
floor, make sure no wires, pipes, or
cables are hidden behind the drill
path for mounting the screws.
2. Open the Safe by using the included key.
Install 4 “AA” batteries aligned with the
markings in the battery compartment.
Set up a PIN code, as explained below.
3. Situate the Safe where you want it and
draw marks through the four mounting
holes onto the mounting surface(s).
Some mounting configurations may use
only two holes on the safe - for better
security, use all four. Move the Safe
and predrill the holes for the 3/8” Bolts.
Fit the Safe over the drilled mounting
holes and secure it with the Bolts.
Operation
Programming your personal PIN
1. Open the Safe, as explained above. Make
sure the batteries are properly installed.
2. Press the Red Button (11) on the inside
of the door near the hinges. The unit
will beep twice and the yellow light
will illuminate. See
FIGURE 1
.
FIGURE 1
Red Button (11)
3.
You only have thirty seconds to enter
your PIN.
Select your 3 to 8 digit PIN and input it
on the Keypad (7). A beep will sound
for each key pressed. Press the letter
“B” to confirm your PIN. After you press
“B”, the unit will beep twice to confirm
you’ve successfully inputted your PIN.
REV 06f
