SKU 92580
For technical questions, call 1-800-444-3353
Page 5
Operation
Battery Installation/Replacement
1.
Open the Battery Cover (5) by unscrewing cap.
See Figure A.
2.
Insert the two 1.5V AA batteries (not included) in the Battery
Compartment (4).
3.
Twist on the Battery Cover (5) and close the Battery Compartment.
Operation Without Illuminator
1.
IMPORTANT: IF YOU ARE NOT IN A DARK AREA, DO NOT REMOVE
THE LENS CAP (7) (NOT SHOWN).
2.
While in a darkened area, remove the Lens Cap (7) and check the
scope operation by pushing the “Green” Night Vision Button (10),
depressing it for 2 to 3 seconds and then releasing it.
(See Figure B).
3.
Look through the Eyepiece. You should see a green glow if the scope
is working properly. The image will gradually fade out, as the Night
Vision Binoculars shut off automatically. Press the “Green” Button (10)
again to refresh, if the image fades before you are done viewing. When
done viewing, replace the Lens Caps (7) immediately.
Figure A
Battery
Cover (5
)
Battery
Compartment
(4)
Eyepiece
