SKU 90548
PAGE 3
ASSEMBLY INSTRUCTIONS
1.
Remove the three tree sections of tree boughs (#1,#2, #3) and the Metal Stand (#6) from
the container. Each section has pre-assembled Christmas Lights with an Electrical Con-
nection that connects from the bottom. Each Section has a “trunk” down the center with a
hole and or a peg. Place the Bottom Section (#3 “E & F”) “trunk” in the hole in the Tree
Stand (#6) and tighten the three Thumb Screws (#5).
See Figure A & B.
3.
When each section is connected at the “trunk”, adjust Thumb Screws (#5) until the tree
stands straight. Plug the Electrical Connections of the pre-assembled Christmas Lights
together-Section #1 into Section #2, #2 into #3. (Replacements bulbs not included).
When this is done, plug an extension cord (not included) into the lowest Electrical
Connection, Section (#3) and plug into a power source.
See Figure C.
READ Warnings on page 2.
4.
Spread branches of the Christmas Tree down to form an attractive tree. It is now ready
to decorate with Christmas ornaments. Caution: Do not use candles on the tree. Never
put flammable ornaments or ornaments made of wood, near the lights.
5.
When storing your Christmas Tree, remove ornaments, unplug all electrical connections,
disconnect the Sections #1,#2,#3 and remove the Stand (#6). Bend boughs of the tree
limbs in close to the trunk for compact storage.
Electrical
Connections
of Pre-Assembled
Christmas Lights
2.
Connect the Middle Section (#2 “C & D”) by placing the ”trunk” peg of that section into the
hole of the Bottom Section (#3 “E & F”). Repeat this step with the Top Section (#1 “A & B”)
See Figure C.
Figure C
#5
Thumb
Screws
#6
Stand
#3
Largest
Tree
Section
#3
#2
#1
Figure A
Figure B
#4
Christmas
Liights
Trunk
