SKU 90444 PAGE 3
INSTRUCTIONS for SETTING THE COMBINATION
1.
Use the combination on the “button pad”. Remove Safe Cover (#2) from the Key Safe by
pushing the Latch (#1) down. Flip Safe Cover over. Use a flat head screwdriver and remove
the four Screws (#13).
See Figure 1 and Figure 2
.
2.
Choose a set combination of numbers (10 Maximum). (Using your birth date or drivers license
number for example. Caution: Do not use the address of the location of the Wall Mount Key Safe).
3.
Choose your combination number and then one at a time, rotate the Buttons (#5) on the back of
the Safe Cover (#2) until the arrows points UP. This locks the button. Proceed with each Button
until the combination selected is complete. Only the buttons selected may be used to open
the lock.
4.
The new combination is now locked into place. The old combination will not work. Replace the
backside of the Safe Cover (#2) making sure that all the Buttons (#5) fit into the slots in the
Safe Cover. Replace the four Screws (#13) that hold the Safe Cover (Backside) to the Safe
Cover.
5.
If you want to change the combination simply repeat the previous steps. Remember when the
arrow points “UP” that number is activated. When the arrow on the Button points “DOWN”, the
Button is not activated.
NOTE:
Always remember to “clear” the lock by pressing the Reset Button (#3) before inputting the
combination. If you press the wrong Button, you must “reset” the lock and re-enter the correct
combination. As a precaution you will need to “reset” the lock before replacing the Safe Cover (#2)
with the key inside. Recheck to see that it is locked before you leave the area.
See Figure 1.
#2
Safe
Cover
Figure 1
#1 Latch
Figure 2
#13
#13
Screws
Four
Places
#2
Safe Cover
(Backside)
Button
Button
Turn
until it
is “UP”
1
2
3
4
5
6
7
8
9
10
“Button
Pad”
#3 Reset
Button
