Page 4
SKU 90360
Operation
Setting Up The Vise
1. Use the Mounting Slots (See
FIGURE 1
) to mount the Vice to your milling machine.
Follow the safety and assembly instructions supplied with your milling machine on the proper
mounting location and safety precautions for mounting a Vise.
FIGURE 1
Using the Vice
Refer to
FIGURE 1
.
1. With a wrench (not included), turn the
Locking Nuts (#15)
counterclockwise to loosen the
swivel
Base (#1)
and swivel the Vise to the desired position. Turn the
Locking Nuts (#15)
clockwise to tighten it in place.
Note:
The Vise has a Scale to assist when swiveling. The
Scale is set in repetitive increments of 0 to 90 degrees. 0 to 90 degrees repeats four times for
a total of 360 degrees. See
FIGURE 1
and Scale Insert.
2. To open the Jaws, turn the
Handle (#12)
counterclockwise until the Movable Jaw (See
FIGURE 1
.) opens to the desired width. Insert the workpiece.
3. Turn the
Handle (#12)
clockwise to tighten the Jaws around the workpiece. Do not over-
tighten the Vise on the workpiece; damage may occur to the workpiece.
4. When you are finished, turn the
Handle (#12)
counterclockwise to loosen the Jaws.
Do not over tighten.
Locking Nut(#15)
Scale Insert
Handle (#12)
Jaw
Jaw
Mounting Slot
Maintenance
1. For better and safer perfomance keep all of the Vise parts clean and
dry at all times.
