Step 4
Attach the Pulling Cable (#11) by setting one end into the hole in the steel bar
located near the Stand (#6). Run the Pulling Cable (#11) through the eyelet and up
toward the Outlet Adjuster (#7). Secure this end of the Pulling Cable (#11) to the
Outlet Adjuster by inserting the end into the hole in the Outlet Adjuster Bar as shown
in Figures 1 and 2.
Figure 1
Figure 2
Outlet Adjuster (#7)
Outlet Adjuster
Bar
Pulling Cable (#11)
steel bar
Stand (#6)
Outlet Adjuster (#7)
Outlet Adjuster Bar
Nut and Washer
Spreader Frame (#2)
Figure 3
Plastic Grip (#9)
Handle (#8)
Operation
When operating your Fertilizer Spreader, it may be helpful to refer to each of the operational Figures
as well as to the Parts List and Assembly Diagram located on the last page of this manual.
Step 1)
Determine the setting necessary for the fertilizer or product to be spread. Consult
the fertilizer instructions to see if a certain setting is recommended.
Step 2)
Move the handle on the Outlet Adjuster to the appropriate setting. The Outlet
Adjustor has markings ranging from 30 to 0, depending on the amount of fertilizer to
be spread-see Figure 2. Setting the Outlet Adjuster to “0” will close the slots and
stop the fertilizer from spreading. The Outlet Adjuster also has a locking Wing Nut to
maintain your setting. Loosen the Wing Nut and set it at the desired mark, then
tighten it into place.
Step 3)
Fill the Spreader Frame (#2) with the desired product. Push the Fertilizer Spreader
over the lawn or garden and it will release fertilizer as it moves.
#90155
Page 4
0 to 30
Wing Nut
Range From
