Page 2
For technical questions, please call 1-888-866-5797.
Item 59789
Specifications
Length
4-11/16"
Height
2-3/4"
Width
4-3/8"
Capacity
2-3/4"
Bushing Set
2 each of 3/8",
1/4", 5/16"
IMPORTANT SAFETY INFORMATION
Use Precautions
1. Read this instruction manual completely before
using the Self Centering Doweling Jig.
2. This product is not a toy. Do not allow
children to play with or near this item.
3. Use as intended only.
4. Inspect before every use; do not use
if parts are loose or damaged.
5. Always wear ANSI approved safety goggles when
working with tools and equipment. Wear a full
face shield if you are producing wood chips.
6. Keep children out of the work area. When
not in use, store this product in a location
that is out of reach of children.
7. Observe work area conditions. Do not use
tools in damp, wet, or poorly lit locations. Don’t
expose to rain. Keep work area well lit.
8. Do not force the tool. It will do the job better
and more safely at the rate for which it was
intended. Do not use inappropriate attachments
in an attempt to exceed the tool’s capacities.
9. Dress properly. Do not wear loose clothing or
jewelry as they can be caught in moving parts.
Non-skid footwear is recommended. Wear
restrictive hair covering to contain long hair.
10. Stay alert. Watch what you are doing. Use common
sense. Do not operate any tool when you are tired.
11. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Note:
There are 4 holes along the top of the Jig.
Only 2 of the holes accept threaded bushings. The
other 2 holes accept 7/16″ and 1/2″ drill bits.
1. Line up the two boards that are to be
connected by the dowels. Set a square (sold
separately) on the side of each board, draw
a vertical mark to show where the dowels
are to be located (see illustration below).
Vertical Marks To Show
Dowel Location
Square Edge
Top Board
Bottom Board
2. Separate the two boards, and clamp the Doweling
Jig over the edge of one board. Align the mark
on the board with the desired dowel diameter
on the Jig (see hole sizes in Guide Block).
3. Insert appropriate bushings, then drill the
dowel hole to the desired depth. The drilled
hole will be centered in the board edge.
4. Apply glue in the holes and on the dowels.
Insert the dowels into the holes and tightly
clamp the boards until glue has dried.
5. The Self Centering Doweling Jig can be used to
make accurate butt joints, miter joints, and edge
joints, as well as acting as a mortising guide.
