Plug
Insert power cord (J) preassembled on fan
assembly (A) into proper wall outlet.
WARNING:
The power cord is equipped
with a three-prong grounded plug that must
be inserted into a matching receptacle. Under
no circumstances must the grounding prong
be cut off the plug. Where a two-prong wall
receptacle is encountered, it must be
replaced with a properly grounded
three
-prong receptacle installed in
accordance with the National Electrical Code
and all applicable local codes and
ordinances.This work must be done only by a
qualified electrician, using copper wire only.
C
13
Hook
H
E
Remove all six front cage screws (H) from edge of
back cage (E).
Place hook at top of front cage (C) over edge at top
of back cage (E).
NOTE
: Make sure hook engages
and all front and back cage holes match up; this will
allow the front cage (C) and the back cage (E) to
hang together while you re-insert the front cage
screws (H) into the the front and back cage holes.
Insert front cage screws (H) into both holes at top of
front cage (C), then tighten. Insert remaining front
cage screws (H). Tighten front cage screws (H),
alternating from one side of front cage (C) to the
other until all front cage screws (H) are completely
secured.
13.
A
10
H
ASSEMBLY INSTRUCTIONS
14.
14
J