6
ASSEMBLY INSTRUCTIONS
4.
6. Remove shade screws (H) from underside of
cage (G) and carefully lower shade (F) and
cage (G) and set aside for later use. Remove
and discard plastic inserts.
A
G
F
6
Hardware Used
x 2
Machine Screw
BB
Attach mounting strap (B) to outlet box (not included)
using the existing washers and outlet box screws or
the machine screws (BB).
NOTE:
If the outlet box
screws required for your outlet box are of a different
size than the machine screws (BB), consult with a
licensed electrician before proceeding.
Tighten machine screws (BB) completely to secure
mounting strap (B) to outlet box.
Turn crossbar on mounting strap (B) so the screws
(D) are level horizontally. [Use a level (not included)
to adjust screws (D) parallel with floor and ceiling as
needed.] Tighten preassembled set screw, located in
the middle of the mounting strap (B), to secure
crossbar.
CAUTION:
The fixture must be mounted to an
outlet box that is supported by the building structure
and can support the weight of the fixture. Plastic
outlet boxes are not recommended.
H
Temporarily place fixture (A) over mounting
strap (B) to determine amount of adjustment
necessary for screws (D); screws (D) should
come through holes in fixture (A) just enough so
decorative nuts (C) will fit flush against fixture
(A) when mounted.
Once screws (D) are adjusted, use pliers (not
included) to tighten nuts (E) on screws (D) until
nuts (E) touch mounting strap (B).
5.
5
Outlet Box
B
A
C
D
E
H
Outlet Box
D
B
4
Crossbar
BB
BB
