MLS1000
OWNER’S MANUAL
6
TOP PANEL
1
REVERB
Reverb is available on both INPUT 1 and INPUT 2. Once sound is running on
either Input, turn up the Reverb knob for that Input Channel to apply more or
less of the effect.
2
BASS AND TREBLE KNOBS
These knobs let you reduce or boost the low and high frequency range
of any input.
3
CLIP LEDS
If a Clip LED lights, turn down that input knob, to avoid distorted sound.
4
INPUT VOLUME KNOBS
The knobs for each INPUT set the volume for the inputs below them.
The INPUT 4 knob sets the volume for Bluetooth as well as the STEREO
INPUT for INPUT 4.
5
CHORUS
Chorus is available for INPUT 2 only, and makes this the ideal input for an
acoustic guitar. Turn the Chorus knob up to apply an increasing amount of
CHORUS, with MILD or HEAVY character.
6
BLUETOOTH AND STEREO AUDIO INPUT
Press the On/Pair button to enable Bluetooth and initiate pairing mode
• To pair, look for MLS1000 from your Bluetooth audio source device.
• LED is lit solid when currently paired, blinking when available for pairing,
and off if Bluetooth has been disabled by a press of the Bluetooth
Off button.
• On/Pair button forces any currently connected Bluetooth audio source to
disconnect, and makes the MLS1000 available for pairing.
• Off button disables Bluetooth. (Bluetooth will be re-enabled if you press the
On/Pair button.)
7
VOICING
Pressing the button selects from the available voicings (DSP tunings) for
different applications:
• Standard: for general use including music playback.
• Live Band: for live band main PA usage.
• Dance Music: for enhanced low and high end impact when playing
bass-heavy or electronic music.
• Speech: for public speaking, may also be helpful for solo performers who
are singing along with acoustic guitar.
8
ROUTING
• Normal (Mono): This unit will output mono audio
• Stereo Master: This unit will operate as the master (left) unit of a Smart
Stereo pair. Use a mic cable to connect this unit’s LINK OUT to the LINK
IN jack of a second MLS1000. All inputs should be connected to the first
master unit, which will also set the volume and tone of both units.
• Link In: Use this setting for the second unit of a Smart Stereo pair. The audio
from LINK IN will be routed directly to the power amplifiers and speakers,
with all other inputs and controls being ignored. This can also be used to
accept mono audio from a previous unit, with that previous unit determining
volume and tone.
1
5
7
8
2
3
4
TOP PANEL
6
