9
Operation
General:
The unit is generally set for use without external timer or coin automat (stand-
alone mode). When the unit has to operate in combination with an external timer
or a coin automat (coin mode), the internal time should be set to 0 minutes as per
procedure below.
depress continuously for 10 seconds
after 10 seconds depress the “-“ button and continue to press
until the display indicates “00”
press once and the unit will bleep in response.
Note: The maximum tanning session is restricted to 30 minutes.
A B C D E F
Operation
Start
Stand-alone mode:
By depressing start once the “+ and –“ buttons can be used to set the
tanning time. Pressing for a second time will start the unit.
Coin mode:
The unit can be started automatically by the external timer or the coin automat.
The start button can be used only when the unit has to be restarted from “pause”.
Stop
Stand-alone mode:
Pressing stop once will cause the unit to “pause”. The lights will go out
but the ventilation will continue to run.
Pressing stop twice will initiate a mandatory after-cooling phase of 3
minutes. The unit cannot be started during these 3 minutes.
Coin mode:
Pressing stop once will cause the unit to “pause”. The lights will go out
but the ventilation will continue to run.
The unit will not respond to pressing stop several times. The external
timer or coin automat will switch the unit off. Switching off will initiate a
mandatory after-cooling phase of 3 minutes. The unit cannot be started
during these 3 minutes.
Illustration after-cooling
Stand-alone mode:
a. Reduce tanning time
b. Reduce body cooler speed
Coin mode:
a. Reduce body cooler speed
Stand-alone mode:
a. Increase tanning time
b. Increase body cooler speed
Coin mode:
a. Increase body cooler speed
Face
Switch the face tanner on and off
Fan
Switch the body cooler on and off
Display messages:
Overrule error (Switch print and/or display print defect)
Filter glass defect (Filter glass of the face tanner is broken or glass
protection is defective)
Communication error (No communication between switch print
and display print)
Note: When you receive one of the above error messages on your LCD
display, you should stop using the unit and remove the plug from the
socket. Contact your dealer.
This symbol will appear on the lcd display after 500 tanning
hours. It is preferable after 500 tanning hours to replace the lamps
with new. After replacing the lamps reset the lamp hour counter.
Note: On the label on the back of the unit the lamps are stipulated that
are suitable for your unit.
Sundry:
Hour counter lamps x 10
Reset hour counter lamps
Hour counter sun bed x10
A
B
C
E
D
F
Summary of Contents for Onyx Pro-Line
