HAPRO Luxura X10, Owner'S Manual

Page: 10 / 144

- 10 -
Operating without an external timer or coin-op:
Press the ‘Start’ button once to decrease the tanning time (start time).
The display indicates the maximum programmed tanning time. Use the button to adjust.
Press the ‘Start’ button once to switch on the sunbed.
Pressing the ‘Stop’ button once while tanning will put the sunbed on pause. The lamps and
ventilation will remain on for four minutes. The tanning time will continue to run. To resume the
tanning session at any time, simply press ‘Start’ again. If the ‘Stop’ button is pressed a second
time, the sunbed will switch off for a mandatory cool-down. The tanning session is now over.
Note:
A. If the sunbed is switched on again less than four minutes after pressing the ‘Stop’
button, the facial tanners may not switch on. These must cool off for four minutes,
after which time they will switch back on automatically.
B. Once the ‘Stop’ button is pressed, the air conditioning will continue running for five
minutes before switching off. The air conditioning also has a required cooling period
of three minutes once these five minutes are up.
C. The tanning time runs out.
Other setting functions:
Unit:
Go to the configuration menu. (from left to right)
Press ‘Start’ to access the Unit sub-menu.
Unit hours:
Select Unit hours. ( 5 )
Unit hours are read-only and cannot be changed.
2 Maxium time
3 Unit type
4 Serial number
5 Unit hours 30
SLi
000001
0