4
Tools Required for Installation
Pre-Installation
1. Carefully unpack case from shipping carton.
2. Set aside the Installation Kit. Items inside will be used
during installation.
3. Make sure to recheck measurement of case for proper
installation clearance.
1/2“ Open Wrench
or Socket Driver
4. Remove any protective foam covering the outside
of the case.
5. Remove the transport safety-brackets that connect the
slatbar to the case.
#2 Phillips Screwdriver
Prepare your ceiling
1. Determine the required opening in the ceiling by measuring the case.
2. Verify your measurements with the the case dimensions that can be found in the chart on page 3.
Use the L2 dimension and the widht of the case, which is 126 mm
3. Make sure you add 8 mm all around the case dimensions and make the cut-out in the ceiling to enable placement.
Karl-Leitl-Str. 1 | 4048 Puchenau |
T
+43 732 70 04 25 |
F
+43 732 70 04 25-55 | [email protected] |
www.hapra.at
