grip slightly to make the engine continually preheat until it
reaches the required temperature. Finally, pull the choke
lever back to its original position (C). During a hot engine
start, put the choke lever in position (C).
Accelerate
RIGHT HANDEL SWITCHES
ENGINE STOP SWITCH
1
The engine can only start up
when the switch is placed
at the “
*
” position, and the
ignition circuit is connected.
If the switch is at the “
%
”
position, the ignition circuit is
cut off. This is an emergency
stop switch.
LIGHT SWITCH
2
“
+
” position
The headlight, front position light, dashboard lights, tail
light will be turned on together.
“
6
” position
The front position light, dashboard lights, tail light will be
turned on together.
“
&
” position
All lights mentioned above will be turned off.
ELECTRIC STARTUP BUTTON
3
#
This button is used for operating the starter motor. With
the ignition switch at the “
*
” position, the engine stop
switch at “
*
” and the transmission in neutral, grasp the
clutch lever and push the electric starter button
#
to
operate the starter motor to start the engine.
B
WARNING
Engaging the starter motor for five at a time can
damage the start motor and wiring harness from
overheating.
B
WARNING
If the electric start function is used continuously,
ensure the duration of each time electric starter
use is not longer than 5 seconds and the interval
between each two usages of the electric starter is
about 10 seconds. High-level discharge will result
in abnormal heating of the starting circuit and the
starter motor. If the engine cannot be started after
several attempts, have it inspected and repaired in
a designated distribution and maintenance facility.
B
WARNING
When cleaning the motorcycle, do not directly
clean its electric parts, particularly its handle
switch.
B
WARNING
Do not use the electric start function and the kick
lever function at the same time.
11
(12)
