NOTE: There is no default username and password to access the camera settings
1) Please setup your own username and password when you access camera settings for the first time.
2) Make sure to set correct date and time for the camera before going in to any additional settings.
3) If camera firmware update is required, it is strongly advised to factory reset on camera to make sure that changes applied successfully
○
Field of View
Follow the steps below on the Wisenet camera configuration webpage
●
Configure camera so that left and right sides are correct, not mirrored.
●
Set camera zoom to capture license plates
●
Adjust camera view angle so that plates pass through the middle of the image.
○
Configure Initial Camera Settings
For proper operations, please, check and set properly:
●
Camera Date Time (see p.9)
●
IP settings (see p.10)
●
Analytics (see p.11)
●
SD card storage (see p.12)
●
Camera exposure and focus (see p.13~15)
●
Check pixel size (see p. 16)
SSDR, WDR, DIS, Defog, AGC and anti-flickering features are good for human eye but affect computer vision performance and
therefore turning them off is strongly advised.
3
CONFIGURING YOUR CAMERA
8 | RoadWatch
Quick Reference Guide
