Technical modifications reserved. Content is protected by copyright. August 2021 M06e/08/2021
Radar Outdoor
Electrical connection
Ÿ
For trouble-free operation the Radar Outdoor require a
hansen
converter of the C100/... series. The Radar Out-
door must only be operated with a converter of this type.
Ÿ
The Radar Outdoor LEDs are operated in series connection
(see connection diagram below).
Ÿ
Connecting the LEDs in parallel, e.g. to 12 volts, is not
permitted and will destroy the LEDs.
Ÿ
The connection of the Radar Outdoor LEDs to the con-
verter must only be made when the system is de-
energized.
Establish and check the connection between the
LEDs and the converter first
before switching on the
mains voltage.
Ÿ
The Radar Outdoor LEDs and the converter are connected
in series as shown in the diagram below:
The POSITIVE pole (red cable) of the converter is
connected to the POSITIVE side of the first Radar-LED.
The NEGATIVE pole (black cable) of the converter is
connected to the NEGATIVE side of the last Radar-LED.
The individual Radar-LEDs are connected to each other
“POSITIVE to NEGATIVE”.
Ÿ
For the connection to the converter or between the Radar
Outdoor LEDs we recommend using the WAGO connector
type 221-412 (article no. 5 0004 013).
Ÿ
When using the converters C100/990 or C100/990D, the
WAGO connectors must be protected with an additional
insulating cap (12 x 30 mm, article no. 5 0004 004).
Ÿ
To prevent ingress of water into the connector/insulating
cap, arrange them in such a way that the cables enter the
connectors from below. This will allow any developing
condensate to flow off.
Ÿ
The Radar Outdoor LEDs are operated in series connection
with a current of 100 mA.
Ÿ
Currents below 100 mA are permitted, whereas currents
above 100 mA are not permitted as they will damage the
LEDs.
Ÿ
The Radar Outdoor system may only be operated with the
following
hansen
converters and the corresponding
maximum number of LEDs stated on the right:
Advice for safe and trouble-free operation:
Ÿ
The specified maximum number of LEDs for the converter
must not be exceeded.
Ÿ
The LEDs must not be operated with a current higher than
the specified rated current.
Ÿ
Individual sections of the Radar-LEDs system must only be
connected with cables approved for the maximum open-
circuit voltage of the converter used.
Ÿ
The electric circuit must not be interrupted while the system
is operational.
Ÿ
For the installation of the LED converters please refer to the
respective installation instructions.
Converters
Converter type
C100/150
C100/300
C100/990
C100/300D
C100/990D
C100/990DALI
Max. no. of LEDs
20
42
150
42
150
150
Converter
Power supply
230 V/50 Hz
+
+
WAGO
connector
WAGO
connector
Connection diagram for Radar Outdoor LEDs and converters
>> Series connection <<
Installation Instructions
Page 2/2
Hansen GmbH
Tel. +49 4843-2009 0
§
§
www.hansen-led.de
