Start-up
Page EN-19
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure adequate air circulation,
– do not place the appliance directly
against the wall. Leave a gap of at least
10 cm to the back wall and 5 cm to the
side.
3. Check the position with a spirit level.
(2)
4. Level out any unevenness on the ground
using both of the front screw feet.
– Close the glass door (1).
– Tilt the appliance backwards slightly and
screw/unscrew the screw feet (2).
– Stand the appliance back up again and
check the alignment with a spirit level.
Repeat the process until the appliance
is standing up vertically. The appliance
should not move when opening the
glass door.
Basic cleaning
To remove the odour that comes with all new
appliances, clean the appliance before us-
ing it (see „Care and maintenance“ on page
EN-15).
Connecting the appliance
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance if
–
it shows visible signs of damage,
e.g. the power cord is defective,
–
it starts smoking or there is a smell
of burning,
–
it makes unfamiliar noises.
In such cases, remove the mains plug
from the socket and contact our ser-
vice department (see page EN-23).
■
Connection to a timer or separate re-
mote control system for the purpos-
es of remotely monitoring and con-
trolling it is not permitted.
■
Do not kink or pinch the mains cord
or lay it over sharp edges. This can re-
sult in a break in the cable.
