Hanseatic HSBS17990WETA3I, User Manual, Page: 53 / 90

Safety Page EN-7
–
it starts smoking or there is a smell
of burning,
–
it makes unfamiliar noises.
In such cases, pull out the mains
plug or unscrew/isolate the fuse and
contact our service department (see
page EN-41).
■
The appliance corresponds to protec-
tion class I and may only be connect-
ed to a plug with a protective conduc-
tor that has been properly installed.
When connecting, make sure that the
voltage is correct. You can find more
detailed information about this on
the nameplate.
■
Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■
The appliance must only be com-
pletely disconnected from the power
supply by pulling out the mains plug.
The appliance must therefore be con-
nected to an easily accessible socket
so that it can be quickly disconnected
from the power supply in the event of
breakdown.
■
If the mains plug is no longer acces-
sible after installation, an all-pole dis-
connecting device complying with
overvoltage category III must be
connected to the house wiring with a
contact gap of at least 3 mm; this in-
cludes fuses, circuit breakers and con-
tactors.
■
Wall mounting of the water filter may
only be carried out by an expert.
■
Please ensure when mounting the
water filter to the wall that
–
the wall is capable of bearing the
weight,
–
there are no cables or pipes in the
drilling areas. Before you drill, use a
metal detector to check the appli-
cable areas.
■
Do not kink or pinch the mains cable
or lay it over sharp edges. This can re-
sult in a break in the cable.
■
When installing the appliance, please
ensure that the mains cable does not
become pinched or damaged.
■
Do not locate multiple portable sock-
et-outlets or portable power supplies
at the rear of the appliance.
■
Please do not position extension
leads or portable power supply units
at the back of the unit.
■
Always hold the mains plug itself, not
the mains cable.
■
Never touch the mains plug with wet
hands.
■
Keep the appliance, mains plug and
mains cable away from naked flames
and hot surfaces.
■
Never immerse the mains cable or
plug in water or any other liquids.
■
If the mains cable of the appliance is
damaged, it must be replaced by the
manufacturer, through the customer
service department or by a qualified
specialist.
■
Inspections and repairs to the appli-
ance may only be carried out by au-
thorised specialists (see „Service“ on
page EN-41).
■
Independent repairs made to the ap-
pliance may cause damage to prop-
erty and personal injury, and any li-
ability and warranty claims will be
forfeited. Never try to repair a defec-
tive or suspected defective appliance
yourself.