■
Bases, drawers, doors, etc. must not
be used as steps or for support pur-
poses.
■
Do not place heavy objects on the ap-
pliance, as they could fall down and
cause injuries.
■
Take care to prevent the risk of trip-
ping when laying the mains cord.
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Always adhere to the prescribed
ambient temperature (see “climate
classes” in the data sheet at the end
of this user manual).
NOTICE
Risk of damage
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■
Only transport the appliance in a ver-
tical position.
■
Allow the cooling unit to stand up-
right for 2 hours before start-up. The
lubricant will fl ow back into the com-
pressor during this time.
Improper handling of the appliance
can lead to property damage.
■
Do not pull or lift the appliance by
the doors.
■
The appliance must only be placed
on a level and fi rm surface. The sur-
face must be strong enough to sup-
port the appliance’s weight when ful-
ly laden.
■
Do not use sharp or pointed objects
to unpack it.
■
When unpacking the appliance, nev-
er damage the insulation material on
the back of the appliance.
■
Do not use any electrical parts inside
the appliance’s cooling chamber that
do not conform to the manufactur-
er’s recommended design.
■
Do not use any mechanical devices or
means other than those recommend-
ed by the manufacturer.
■
The interior light must only be used
to illuminate the interior of the appli-
ance. It is not suitable for lighting a
room.
■
Do not use any means other than
those recommended by the manufac-
turer to speed up defrosting. For ex-
ample, do not use any electric heat-
ing equipment, knives or devices with
an open fl ame such as a candle. The
thermal insulation and the interior
are scratch and heat-sensitive and
can melt.
■
When cleaning, please note:
–
Never use harsh, granular, soda,
acid, solvent-based or abrasive
cleaners. These attack the plastic
surfaces. All-purpose cleaners with
a neutral pH are recommended.
–
Door seals and plastic parts are
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
–
Use only soft cloths for cleaning.
■
Wait 5 minutes after switching off.
Only then switch the appliance on
again.
■
Only use original accessories.
Safety
Page GB-9
Summary of Contents for HKS 8555A3I
Page 30: ......
