Start-up
Page EN-19
5. Unscrew the three fixing screws for the
hinge plate and the two screws on the op-
posite side. To do this, use an 8mm span-
ner or a cross-headed screwdriver.
6. Remove the hinge plate.
7. Screw the hinge plate as well as the two
screws back onto the respective opposite
side.
8. Place the cover back on the refrigerator.
Push down on both sides (left and right)
of the front of the cover until you hear it
click into place.
9. Screw the two screws tightly back onto
the cover. To do this, use a cross-headed
screwdriver. Secure the two screw cov-
ers.
Changing the lower hinge
(3)
10. Tilt the refrigerator backwards (max. 45 °).
11. Unscrew the two front screw feet (3).
12. Unscrew the lower hinge plate. To
do this, use an 8mm spanner or a
cross-headed screwdriver.
13. Move the hinge pin to the opposite side
of the hinge plate. To loosen and tighten
the nut, use a 10 mm spanner or the
bottom of a screw foot.
14. Screw the hinge plate tightly back onto
the opposite side. Make sure that the
hinge pin is in the hinge bushing of the
door.
