Page EN-8
Safety
Risk of injury!
People may trip over the open appli-
ance door.
■
Note that the door should not be left
in the open position since this could
present a tripping hazard.
■
Close the appliance door after every
use.
■
Only leave the appliance door slightly
open to cool down.
NOTICE
Risk of damage to property!
Improper handling of the appliance
may result in damage to the appliance
itself.
■
Only use dishwasher salt that is suita-
ble for dishwashers.
■
Only add dishwasher salt immedi-
ately before the next main dishwash-
ing cycle, as dishwasher salt that has
overfl owed can damage the seals and
fi lters of the appliance.
■
Immediately remove any spilt dish-
washer salt with a damp towel, as
otherwise the stainless steel surface
can be damaged.
■
Ensure that the dishwashing deter-
gent and rinse aid are suitable for the
appliance.
■
Wipe away rinse aid that has over-
fl owed immediately, as otherwise it
can lead to excessive foaming which
can compromise the results delivered
by the dishwasher.
■
Do not overload the appliance.
■
Position the upper dish rack at the
highest setting if very tall dishes are
in the lower dish rack, as otherwise the
upper spraying arm will be blocked.
The door seals are sensitive to oil and
grease. Oil and grease can damage the
door seals.
■
Do not apply grease to the door seals.
■
Wipe away grease and oil that has
dripped onto the edge of the open
appliance door.
The surfaces can be damaged by un-
suitable cleaning agents.
■
Do not use harsh, aggressive, sol-
vent-based or abrasive cleaners.
The appliance is designed for a water
pressure of 0.4 to 10 bar (0.04 to 1.00
MPa).
■
If the water pressure is higher than
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
■
Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
■
Ensure that the inlet hose is not
kinked and is carefully connected.
■
Do not cut through the inlet hose.
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist.
■
Do not use old or previously installed
inlet or outlet hoses. Only use the sup-
plied hoses.
■
The outlet hose must be of a mini-
mum diameter of 40 mm so that the
water can be pumped away unhin-
dered.
■
Do not attach the outlet hose your-
self, have it installed by a special-
ist plumber. Have the outlet hose
checked regularly for damage or
kinks.
Summary of Contents for HG5544D63602EW
Page 38: ......
