First use
page EN-23
Electrical connections
WARNING
Risk of electric shock!
Touching live parts may result in severe
injury or death.
■
Do not operate or continue to oper-
ate the appliance if
–
it shows visible signs of damage,
e.g. the power cord is defective,
–
starts smoking or there is a smell of
burning,
–
makes unfamiliar noises.
In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our Service de-
partment (see page EN-29).
■
Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■
If the mains plug is no longer acces-
sible after the appliance has been
connected, an all-pole disconnecting
device complying with overvoltage
category III must be connected up-
stream in the domestic installation
with a contact gap of at least 3 mm;
consult a qualified professional if nec-
essary (see “Service” on page EN-29).
■
Do not kink or pinch the mains cable
or lay it over sharp edges. This can re-
sult in a break in the cord.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fire and damage to property.
■
Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
NOTICE
Risk of damage to property!
If the cooling unit has been transport-
ed horizontally, lubricant from the com-
pressor may get into the cooling circuit.
■
If possible, do not tilt the cooling ap-
pliance horizontally.
■
Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to flow
back into the compressor.
• Insert the mains plug into an easily ac-
cessible and properly installed socket
(220–240 V~ / 50 Hz).
You will find all important information
about operation from page EN-10.
