Start-up
Page EN-19
Start-up
WARNING
Risk of injury!
■
The appliance is heavy and bulky.
During transport, when setting up
and positioning the appliance, get
help from another person.
■
Freezer baskets, doors, etc. must not
be used as steps or for support pur-
poses.
Health hazard caused by refrigerant!
■
Do not damage the refrigeration cir-
cuit, for example by piercing the re-
frigerant channels of the condensate
vaporiser with sharp objects, cutting
off the tubing, etc.
■
Refrigerant is fl ammable when spurt-
ing out and can damage the eyes. In
this case, rinse your eyes in clean wa-
ter and seek medical assistance im-
mediately.
■
To prevent the formation of a fl am-
mable gas-air mixture in the event of
a leakage in the refrigeration circuit,
the installation space must have a
minimum size of 1 m
3
per 8 g of refrig-
erant in compliance with the EN 378
standard. The amount of refrigerant
contained in your appliance can be
found in the technical data (see
see from
page EN-26).
■
Do not place heat-emitting applianc-
es such as microwaves, toasters etc.
on the appliance and do not operate
any electrical appliances inside the
appliance.
NOTICE
Risk of damage!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. This
can then lead to an increase in temper-
ature inside the appliance.
■
Observe the specifi ed ambient tem-
perature (see
see "Intended use" on
page EN-5).
Improper handling of the appliance
may result in damage.
■
If possible, do not tip the appliance
horizontally, but transport it at a
maximum inclined angle of 45°
45°.
■
Do not use sharp objects to unpack
the appliance.
Moving and unpacking
• Tape the castors under the chest freezer
with adhesive tape to ensure stability dur-
ing transport.
• Transport the chest freezer using a trolley
or with the help of a second person.
• Remove the adhesive strips from the cas-
tors. Lift the chest freezer slightly onto its
left side and push or pull it until it reaches
the desired position.
• Unpack the chest freezer and carefully
remove all packaging, plastic moulding,
adhesive strips and foam padding from
the inside, outside and back of the chest
freezer.
