Start-up
Page EN-17
Setting up and aligning the
appliance
1. Place the appliance on as flat and as firm
a base as possible.
2. To ensure adequate air circulation,
– the entire space above the appliance
must be clear.
– the appliance should not stand directly
against the wall. Keep the appliance at
least 3 cm away from the rear wall.
3. Level out any unevenness on the ground
using the levelling feet (7) at the front. To
do this
– Close the door.
– Tilt the appliance backwards slightly.
– Turn the levelling foot inwards or out-
wards until the appliance is level.
– Reposition the appliance upright.
4. Check the position with a spirit level.
The appliance should not move when open-
ing the door.
About climate categories
• Always ensure the prescribed ambient temperature is maintained see ‘Intended use’ on
page EN-5.
Climate category means that the appliance is intended for operation at the specified ambient
temperature.
Zone description
Code Definition
Extended temperate zone
SN
This refrigerator is designed for use at ambient temper-
atures of +10 °C to +32 °C.
Temperate zone
N
This refrigerator is designed for use at ambient temper-
atures of +16 °C to +32 °C.
Subtropical zone
ST
This refrigerator is designed for use at ambient temper-
atures of +16 °C to +38 °C.
Tropical zone
T
This refrigerator is designed for use at ambient temper-
atures of +16 °C to +43 °C.
If the room temperature drops significantly below this, the unit will not switch on as often. This
indicates that an unwelcome increase in temperature may occur.
