20
TURN ON THE APPLIANCE AND SELECT PROGRAMME
Change programme
Premise:
1. You can change the programme only if it runs for a short time. If the detergent is released from the
dispenser the water will be pumped out. If this is the case, the detergent dispenser must be refilled (see
the section entitled “Add the detergent”).
2. Press the Start/Pause button. The dishwasher will pause. Press the programme button more than 3s
to set the desired programme setting (see the section entitled „Starting a wash cycle”).
NOTE:
When you open the door during the washing cycle, the dishwasher stops. Programme indicator
will stop flashing and beeps will continue every minute until the door is closed. When the door
is closed, the appliance will resume the programme after 10 seconds. The appliance features a
memory function and it will complete the selected program after a power outage.
The dishwashing programme completes
When the dishwashing programme completes, the dishwasher beeps for 8 seconds. Press on/off button
to turn off the appliance. Close water supply tap and open the dishwasher door. Wait a few minutes
before unloading the dishwasher. Allow dishes to cool. Hot dishes are more susceptible to breakage.
Also the dishes will dry.
Turn off the dishwasher
The programme is completed only when the programme indicator is on, but not flashing.
1. Press on/off button to turn off the appliance.
2. Close water supply tap!
Open the door carefully.
Hot dishes are more susceptible to breakage. Before unloading the dishwasher leave the dishes to cool
for about 15 minutes.
Open the dishwasher door, leave it ajar and wait a few minutes before removing the dishes. This will
allow the dishes to cool and dry.
Unload the dishwasher
It is normal that the dishwasher interior is wet. First remove dishes from the lower basket and then from
the upper basket. This will prevent water dripping from the upper basket on the dishes in the lower
basket.
