Hansa AMGF20M1GBH, Instruction Manual

Page: 77 / 100

77
INSTALLING THE APPLIANCE
EN
- Remove all packaging materials and components.
- Check the oven for damage such as dents or door misalignment or breakage.
- Remove any protective film from the surface of the cabinet.
- Do not install the oven if it is damaged.
Do not remove the light brown mica cover bolted into the recess in order to shield the micro-
wave magnetron.
Installing
1. The appliance is designed for household use only.
2. The appliance can be used only after fitting in kitchen furniture.
3. For fitting instructions, please refer to "Installation guide"*.
4. Microwave oven should be installed in a cabinet with a width of 60 cm and a height of 85 cm from the
kitchen floor*.
Do not remove the legs located in the bottom of the appliance*.
Blocking the inlet and outlet openings may damage the microwave oven.
Place the oven as far away from radio and television as possible. Operating microwave oven may cause
interference to radio and television reception.
2. Insert the oven power plug into a standard household wall socket.
Make sure beforehand whether voltage and frequency are the same as on the oven's rating plate.
WARNING: Do not install the oven on the gas hob or other heat producing appliance. In the event of
such installation, the oven may be damaged and void the warranty.
Accessible surfaces
may become hot
during operation.
open
30cm
7,5 cm
7,5cm
* Applicable to built-in appliances