2
English
Technical Information
Water pressure
Recommended
15 - 75 PSI (0.1 - 0.5 MPa)
Maximum
145 PSI (1 MPa)
Hot water temp.
Recommended
120°-140° F (48° - 60° C)*
Maximum
158°F (70° C)*
Flow rate
75010XX1, 75020XX1,
1.2 GPM (4.5 L/min)
75042XX1
75200XX1
2.0 GPM (7.6 L/min)
Hole size in mounting surface
1⅜" (35 mm)
Max. depth of mounting surface
1⅝" (40 mm)
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
• The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
• This drain is intended for use in a sink with an
overflow. If your sink does not have an overflow, or
if this drain is too small for the hole in your sink,
please refer to the instructions included with the
sink. Some sinks include special drain installation
instructions and/or parts. Others require the use of
a specialty drain. Hansgrohe is not respnsible for
the cost of a specialty drain.
The hot and cold supply hoses included
with this faucet are for use with ⅜ stops.
If your stops are a different size, purchase
adapters at your local plumbing supply
store or home center. Adapters are not
available from Hansgrohe.
•
75042XX1
: This faucet does not include a drain
or a pull rod.
•
75200XX1
: The discharge water temperature
from a bidet fitting shall be limited to a maximum
temperature of 110ºF (43ºC) by a water temperature
limiting device conforming to ASSE 1070.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.