Important!
The fitting must be installed, flushed
and tested after the valid norms.
Assembly
Flush through the supply pipes.
Place the mixer including the sealing washer in
position on the sink.
Slip the plastic washer, the slide washer, the
metall washer and collar nut over the hose
and threaded base and tighten the collar nut
by hand. If there is not enough space, please
use only the slide washer and the metall with
out the plastic washer.
Tighten screws.
Connect the connecting hose / supply pipes
to the angle valves;
cold right hot left.
Large differences in pressure between the hot and
cold water supply should be balanced.
Operation
The mixer is activated by pulling the lever handle.
Turning to the left = cooler water,
turning to the right = warmer water.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure: 0.1 0.5 MPa
Test pressure:
1.6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.:
65° C
Rate of flow by 0.3 MPa:
13 l/min
Hansgrohe single lever mixers can be used togeth
er with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0.15 MPa.
To adjust the hot water limiter on single lever mix
ers, please see page 14.
No adjustment is necessary when using a continu
ous flow water heater.
1.
2.
3.
4.
5.
English
Spare parts
(see page 3)
llever head
38091000
1.1 screw cover
96338000
flange
96468000
nut
96461000
cartridge cpl.
92730000
aerator cpl.
13913000
fixation cpl.
95049000
connection hose 900 mm
98785000
spout cpl.
92830000
sealing set
92646000
1.
2.
3.
4.
5.
6.
7.
8.
9.
