6
Install the Pop Up Drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the
tee.
Unscrew the tailpiece from the tee.
Wrap the threads with Teflon tape
and replace.
Install the flexible sealing gasket to the
flange. Sit it in the sink outlet.
From under the sink, install the black
mack gasket, white friction ring, and
retainer nut to the flange. Do not tighten
the nut against the bottom of the sink at
this time.
Thread the tee and tailpiece to the
flange. The pivot must face the faucet.
If necessary, turn the drain assembly.
Tighten the retainer nut.
Sit the plunger assembly in the drain.
Install the horizontal rod through the
pivot ball seals and into the tee so that
the end goes through the loop in the bot-
tom of the height adjuster. The two pivot
ball seals should surround the pivot ball.
Slide the link over end of pull rod.
Tighten screw.
Slide one end of spring clip over end
of horizontal rod. Slide link over end
of horizontal rod. Test motion of drain
plunger. Reposition link as necessary. There are multiple holes in the linkage -- the horizon-
tal rod may go through any of the holes.
When satisfied with the action of the drain, slide the other end of the spring clip over the
end of the horizontal rod.
plunger
flange
sealing gasket
mack gasket
friction ring
retainer nut
pivot
tee
tailpiece
link
spring clip
nut
horizontal rod
pivot ball
pivot ball seals
height
adjuster