Hans Grohe LavaPura Uno Shower Toilet E 305 22406007, Instructions For Use/Assembly Instructions

Page: 12 / 32

12
Installation of the remote control
2. Charging method of the wireless rechargeable remote control :
10
①
Press the remote control hanger upright against the pre-installation area on the wall,and mark the positions of the two
mounting holes on the wall with the marking pen. Drill holes at the positions marked on the wall with a φ 6 mm drill bit,
at a depth of 35 mm.
(When determining the installation position, you need to mark sure that a person can easily reach the remote control by
hand when sitting on the seat)
1. Installation of remote control hanger
②
Insert the expansion tubes into the holes in the wall; press the hanger against the wall, with the holes on the hanger
aligned with the expansion tubes; insert the screws and tighten them; and then cover them with the silicone pads.
③
Place the remote control in the hanger (which has a magnetic absorption function).
Do not install and use this product in a damp environment. Do not place it in a place where it is likely to be damped with water.
Remove the remote control from the hanger, and place it on the lid (at the area shown in the figure below) for wireless
charging. This area has a magnetic absorption positioning function.
Indicator of three-level status in remote control
lights up cyclially during charging, and always
turns on when fully charged.