English
close
cold
hot
open
Operation
Important!
The fitting must be installed, flushed and
tested after the valid norms!
The mixer can not used together with a continuous flow
water heater.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in posi-
tion on the basin.
3. Slide the fixation piece including the washer over
the threaded pins and tighten the nuts.
4. Connect the supply pipes to the isolation valves;
5. cold right - hot left.
6. Connect the Isiflex hose with the handshower and
the mixer.
The hot and cold supplies must be of equal pressures.
Operation
The handshower is activated by pressing the button, the
spout of the mixer is closed. After the button is released,
the handshower is closed und the spout of the mixer is
activated.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure: 0,25 – 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80°C
Recommended hot water temp.:
65°C
Rate of flow mixer:
6,5 l/min 0,3 MPa
Rate of flow handshower:
8,5 l/min 0,3 MPa
Spare parts
(see page 3)
1
flange
97155000
2
handle
10092000
3
nut
97157000
4
cartridge cpl.
96339000
5
aerator
97691000
6
supply pipe
96638000
7
Isiflex shower hose
28246000
8
hand shower
96907000
9
chain for plug
97109000
10 shower holder
28331000
11 fixing set
97774000
12 handle
39091000
13 flange
96671000
14 aerator
13085000
15 flange
95396000
16 shower holder
39525000
