ALF41615
PARTS LIST
DESCRIPTION
ORDER PART #
NUT COVER
BOLT COVER
HEX BOLT DRIVER
HEX WRENCH
1/4" NUT
Ø
6.5 X 1.0 MM
WASHER
1/4" X 18 MM BOLT
TABLE LEG
LEG CONNECTOR
BRACKET
TABLE TOP
QTY
8
8
1
1
16
8
8
4
1
1
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
HW0027
HW0105
HW0006
HW0009
HW0004
HW0014
HW0035
FC0069
FOOT CAP
FACTORY ASSEMBLY
A
B
C
D
E
F
G
H
I
J
K
G0003
1
TOUCH-UP PAINT
Step3:
Attach a leg to the leg connector bracket by carefully
guiding the bolts already in place on the table legs
(each leg has two bolts) through the holes in the leg
connector bracket. Add a washer and a nut to the end
of each bolt. Hand tighten three to four turns only.
Do
not tighten completely.
Repeat on the other three legs.
Step 1:
Remove all protective materials and set parts on a
flat, non-abrasive surface. Identify parts packed in
carton against the parts list. If you are missing any
parts or are unsure how to proceed with assembly,
call our Customer Service Center at 1-800-416-3511.
Do not attempt assembly if any parts are missing
or damaged.
Step 2:
Place the table top upside down on a flat, non-
abrasive surface. Attach the table leg to the table top
by using the bolts and washers as shown in the diagram.
Guide the bolts through the holes in the table leg, and
into the pre-drilled holes in the table top. Hand tighten
three to four turns only.
Do not tighten completely
.
Some adjustments may be necessary to ensure proper
alignment of the table legs. Repeat for the other three
legs.
Step 4:
After making any necessary adjustments to the
alignment of the table legs and the leg connector
bracket, use the hex bolt driver and hex wrench to
tighten all nuts and bolts.
Note:
each bolt and nut
must be tightened a few revolutions at a time. In
order to apply equal pressure to all bolt joints, we
recommend working in a cross corner (X fashion).
Repeat until all bolts are tight.
Do not over tighten
.
Over tightening may strip bolts. Cover all nuts and
bolts with covers.
Step 5:
With the help of another person, turn the table in the
upright position. Your table is now ready for use. If
you have any questions, please call our Customer
Service Center at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames
resulting from over tightened bolts or improper assembly
is not covered under our warranty. Please read all
instructions carefully before assembly. If you have any
questions regarding your assembly, call our Customer
Service Center at 1-800-416-3511.
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
FOOT CAP
E
F
H
D
F
G
A
C
B
UMBRELLA POLE
STOPPER & NUT
FACTORY ASSEMBLY
G0091
& HW0448
G0235 & G0236
UMBRELLA HOLE
RING (SET)
FACTORY ASSEMBLY
