Page 4
ASSEMBLY
INSTRUCTIONS
F
1
igure
Figure 2
1
2
Place the table rim upside down on a flat, non-abrasive surface.
igure
Attach the table legs to the table rim
by using four bolts and washers as shown in
F
1
. Guide the bolts through the holes in the table
leg into the pre-drilled holes in the table top.
Hand tighten only 2-3 turns.
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver to tighten
all bolts. Repeat until all bolts are tight.
Do not over
tighten.
Over tightening may strip bolts. Cover all
nuts and bolts with covers.
FOOT CAP
E
D
B
Attach a leg to the leg connector brackets by carefully guiding the bolts already in place on the table legs
(each leg has four bolts) through the holes in the leg connector brackets. Add a washer and a nut to the
end of each bolt as shown in
F
2
.
Hand tighten only 2-3 turns.
Repeat for the other three legs.
igure
With the help of another person, turn the table in the upright position. Note the clear table bumpers spaced
evenly throughout the inside of the table rim. Carefully place glass inside the rim, resting on the bumpers.
4
C
H
G
F
G
I
J
