ASSEMBLY INSTRUCTIONS
1
2
C
A
3
B
F
1
igure
Figure 2
E
F
H
Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table
legs (each leg has two bolts) through the holes in the leg connector bracket. Add a washer and a nut
to the end of each bolt as shown in
.
Repeat on the other three legs.
F
1
Hand tighten only.
igure
Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by
using the bolts and washers as shown in
. Guide the bolt through the hole in the table leg,
into the pre-drilled holes in the table top.
Repeat for the other three legs.
F
2
Hand tighten only 2-3 turns.
igure
D
F
G
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex
wrench to tighten all bolts. Repeat until all bolts are tight.
Over tightening may
strip bolts. Cover all bolts with covers.
Do not over tighten.
FOOT CAP
