Page 4
ASSEMBLY INSTRUCTIONS
1
2
Place the table rim
upside down on a flat, non-abrasive surface. Attach the table leg to the table
rim by using the bolts and washers as shown in
. Guide the bolts through the holes in the table leg, into the
pre-drilled holes in the table rim.
Repeat for the other three legs.
(without glass)
Fig 2
Hand tighten only 2-3 turns.
.
Attach a leg to the leg connector bracket by carefully guiding the bolts already in place on the table legs (each
leg has two bolts) through the holes in the leg connector bracket. Add a washer and a nut to the end of each bolt
as shown in
.
Repeat on the other three legs.
.
Fig 1 Hand tighten only 2-3 turns.
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench to
tighten all bolts .
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to
all bolt joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
Over tightening may strip bolts. Cover all bolts with covers.
Note:
Do not over
tighten.
FOOT CAP
4
With the help of another person, turn the table in the upright position. Note the clear bumpers spaced evenly
throughout the inside of the rim. Carefully place the glass top inside the rim, resting on the clear bumpers.
D
C
I
E
G
H
B
F
G
