ASSEMBLY INSTRUCTIONS
1
FOOT CAP
SWIVEL PLATE
"U" BAR
C
G
I
D
E
H
F
A
B
Position the swivel base on a flat, solid surface. Make sure the swivel plate is positioned all the way into
the base. It may have vibrated out during shipment. The two sets of holes in the swivel plate should be
facing away from you.
Note the arrows on both the swivel plate and the "U" bar portion of the chair frame. Position the chair frame
onto the swivel plate so that the two pairs of holes in the "U" bar are exactly aligned with the two pairs of
holes in the swivel plate and the arrows on both the "U" bar and swivel plate are pointing in the same
direction. Proper positioning of the chair frame on the swivel plate/swivel base assembly, and proper
alignment of the holes in the "U" bar with the holes in the swivel plate are critical to the safe, well balanced
swiveling motion of the chair.
Carefully examine the diagram. Attach a metal plate to two (2) bolts and guide the bolts through the top of
one set of holes in the "U" bar (located at the bottom of the chair frame) and into the pair of holes in the
swivel plate. From beneath the swivel plate, add a washer, then a spring washer and a nut to the end each bolt.
Hand tighten 3-4 revolutions only. Repeat procedure for pair of holes on the opposite side. Again, hand
tighten nuts 3-4 revolutions only. Do not tighten nuts completely.
Using the hex wrenches provided, tighten the nuts and bolts. Be sure the bolts are fully tightened. Remove
arrow labels from the “U” bar and swivel plate. Cover bolts and nuts with covers. Your chair is now ready
for use.
2
3
