ASSEMBLY
INSTRUCTIONS
1
2
After making any necessary adjustments to the alignment of the chair, use the hex bolt driver to tighten all
bolts.
Note:
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all
bolt joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
Do not over
tighten.
Over tightening may strip bolts. Cover the bolts with covers provided.
Page 4
Place the table top upside down on a flat, non-abrasive surface. Attach a side leg to the table top by using a
1/4"x20 mm bolt and a washer as shown in the
.
Hand
tighten only.
Do not tighten completely
. Some adjustments may be necessary to ensure proper alignment of
the table legs. Repeat for the other three side legs. Attach the middle leg using the 1/4"x20 mm bolts and
washers as shown in the
. Hand tighten only.
Do not tighten
completely
. Repeat for the other middle leg.
Fig.1
Place the leg beneath the table rim corner bracket. Guide
the bolt through the hole in the table rim corner bracket and into the pre-drilled hole in the side leg.
Fig.1
FOOT CAP
H
G
E
H
E
G
A
C
D
Fig.1
3
Attach a side leg to the leg connector bracket by carefully guiding the bolts already in place on the side legs
(each leg has two bolts) through the holes in the leg connector bracket as shown in the
. Add a washer
and a nut to the end of each bolt.
Hand tighten only. Do not tighten completely.
Repeat on the other three
side legs.
Fig.2
Attach the middle leg to the leg connector bracket by using the 1/4"x28 mm bolts and washers as
shown in the
. Guide the bolt with washer through the hole in the leg connector bracket, into the
pre-drilled hole in the middle leg.
Hand tighten 3-4 revolutions only. Do not tighten completely.
Repeat
for the other middle leg.
Fig.2
G
I
J
H
G
F
B
Fig.2
