Page 4
ASSEMBLY INSTRUCTIONS
1
2
3
Assemble furniture on a smooth, non-abrasive surface.
by using two
5/16"x40 mm bolts and washers as shown in
. Guide the bolts through holes in back frame, into
pre-drilled holes in the
.
and back frame
by using four 5/16"x25 mm bolts and washers as shown in
.
A
and seat frame by using two 5/16"x25 mm bolts and two 5/16"x40 mm bolts and four washers as
shown in
.
Fig.1
Hand tighten only.
Fig.2 Hand tighten only.
Fig.3 Hand tighten only.
Attach the back frame to right arm
right arm
Attach the seat frame to right arm
ttach the left arm
to back
B
D
I
G
H
Fig.1
I
G
H
A
Fig.2
I
F
H
I
F
H
C
Fig.3
I
F
H
I
G
H
Attach the complete base to the complete seat by using four 5/16"x40 mm bolts and washers as shown
in
. Guide the bolts through holes in base, into the pre-drilled holes in the seat.
Fig.4
Hand tighten only.
Using the hex bolt driver provided, tighten all bolts.
Test the operation of glider. Gliding
motion should be smooth. Adjust tension on the glider brackets, nuts and bolts as needed. Cover nuts
and bolts with covers provided.
Do not over tighten bolts. If nuts and bolts are
too tight or too loose, the glider will not function properly.
I
G
H
Fig.4
E
I
G
H
