ASSEMBLY INSTRUCTIONS
1
2
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex
wrench to tighten all bolts and nuts. Repeat until all bolts are tight.
Over tightening
may strip bolts. Cover all bolts with covers. With the help of another person, turn the table in the upright
position.
Do not over tighten.
Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by
using two bolts and washers as shown in the diagram. Guide the bolts through the holes in the table
leg, into the pre-drilled holes in the table top.
Repeat on the other legs.
Hand tighten 2-3 turns only.
Page 4
E
C
D
A
B
