ASSEMBLY INSTRUCTIONS
1
2
Attach a table leg to the leg connector bracket by using two 1/4"x30 mm bolts and Ø6.5x1.0 mm washers as
shown in
. Guide the bolts through holes in leg connector brackets into pre-drilled holes in the legs.
Repeat for other three table legs.
Fig 1
Hand
tighten only.
Place the table top upside down on a flat, non-abrasive surface.
a table leg
ig.2
Attach
to the table top by using two
1/4"x35 mm bolts and Ø20xØ6.5x2.0 mm washers as shown in
. Guide the bolts through the holes in the table
leg into the pre-drilled hole in the table top.
Repeat for the other table legs.
F
Hand tighten only.
B
FOOT CAP
C
H
D
F
A
H
E
G
3
After making any necessary adjustments to the alignment of the table, use the hex bolt driver and hex wrench to
tighten all bolts .
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure
to all bolt joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
Over tightening may strip bolts. Cover all bolts with covers.
Note:
Do not
over tighten.
