Page 4
ASSEMBLY INSTRUCTIONS
1
Place all parts on a flat, non-abrasive surface. Attach the chair frame to the chair base by using the bolts and
washers as shown in
. Guide the bolts through the holes in the chair frame, into the pre-drilled holes in the
chair base.
Repeat for the opposite side.
Fig 1
Hand tighten only 2-3 turns.
.
2
After making any necessary adjustments to the alignment of the chair, us the hex wrench to tighten all bolts .
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all bolt
joints, we recommend working in a cross corner (X fashion). Repeat until all bolts are tight.
Over tightening may strip bolts. Cover all bolts with covers.
Note:
Do not over tighten.
B
A
C
D
E
CHAIR FRAME
(CROSS SECTION)
CHAIR BASE
(CROSS SECTION)
C
D
E
FOOT CAP