Page 4
ASSEMBLY INSTRUCTIONS
1
2
After making any necessary adjustments to the alignment of the table, use the hex bolt driver to tighten
all bolts. Repeat until all bolts are tight.
Over tightening may strip bolts. With the
help of another person, turn the table in the upright position.
Do not over tighten.
Place the table top upside down on a flat, non-abrasive surface. Attach a table leg to the table top by
using the eight bolts and washer as shown in the diagram. Guide the bolts through the holes in the
table top, into the pre-drilled holes in the table leg.
Repeat on the other
legs.
Hand tighten 2-3 turns only.
A
B
D
E
C
