Hanover HSD0411, Assembly & Care Manual

Page: 8 / 10

Reset Operation: 1. When the height of the device is incorrect or an error code appears, the
device needs to be reset and corrected. Press and hold the button”3” and button”4”
simultaneously for 3 seconds to enter this function.
2. After entering the reset function, the display shows “RST”, press and hold the “
▼
” button to
reset the device. When the desktop descends to the lowest height, it will bounce upward
and run until it is displayed “bot”, that is, the reset is completed.
Adjust the Anti-Collision Sensitivity: 1. Press and hold the ”
▲
”button and ”
▼
”button
simultaneously for 3 seconds to switch the sensitivity. Switch 1 gear for every operation, there
are 4 gear range, A-0, A-1, A-2,A-3.
2. When the display shows “A-0”, the desk turns off the anti-collision function; “A-3” for high
sensitivity; “A-2” for middle sensitivity; “A-1” for low sensitivity. (Factory default A-0)
3. When the desk rises or descends, it will rebound immediately when it encounters an
obstacle to protect.
Troubleshooting:
1. Reset: When the LED shows" " or " ", press and hold “
▼
”button to reset the desk,
when the desktop descends to the lowest height, it will bounce upward and run until the LED
shows “bot”, that is, the reset is completed.
2. When it does't work and the LED shows "E01" or "E02", please retry 18 mins later.
3. If the “
▼
” button does't work, and the LED shows other code, please check the cable connection
and then cut off thepower for at least 10 seconds. Reconnect to the power and press “
▼
” button to
start the reset process when it shows the " " or " " .
4. If all these above process are inefficient, plz contact our customer service.