ASSEMBLY INSTRUCTIONS
3
4
Insert the wheel into the threaded hole at the bottom of the serving cart rear leg as shown in
. Use the hex
wrench to tighten the axle of the wheel. Repeat on the opposite side.
Fig. 3
After making any necessary adjustments to the alignment of the serving cart, use the hex bolt driver to tighten all
bolts.
each bolt must be tightened a few revolutions at a time. In order to apply equal pressure to all bolt
joints, we recommend working in a cross corner (X) fashion. Repeat until all bolts are tight.
.
Over tightening may strip bolts. Cover all bolts with covers provided.
Note:
Do not over tighten
D
